SC10 Precision Ball Bearing Steering Rack

Increase steering performance with our precision ball bearing steering rack. Eliminates looseness and end-play in steering system. Decreased friction improves steering response which provides faster steering input. Optimized rack length for near zero bump steer. Precision CNC machined to remove excess weight without reducing strength.

• Only 2 grams with bearings!
• Heat-treated aircraft aluminum
• Precision ball bearings and mounting hardware
• Available is Factory Blue or Stealth Black anodized color
• Fits SC10, SC10B, T4, B2, B4, etc...

SC10 Precision Ball Bearing Steering Rack
$18 each

Precision Ball Bearing Steering Rack for B44,B44.1,B44.2
$18 each

Stainless Steel Chassis Pan

Increase your cars handling with this precision laser-cut, CNC machined, and formed chassis pan. By adding weight down low, the center of gravity height is reduced, which increases traction to the inner tires for faster cornering speed. With a increase in sprung weight, the un-sprung weight ratio is effectively reduced allowing for faster speeds over rough terrain. Increases chassis stiffness and makes the chassis virtually indestructible. Easily tune your chassis for different tracks, installs in two minutes.

• Lowers center of gravity for faster cornering speeds
• Increases un-sprung weight ratio for faster speed over bumps
• Increases chassis stiffness for better steering control
• Made from 0.045 thick high strength stainless steel (206 grams, 7.2 oz.)
• Fits SC10, SC10B, SC10.2

Stainless Steel Chassis Pan
$45 each

Lightweight Steel Ball Diff Outdrives

Increase performance with these lightweight outdrives. Less rotating mass allows your car to accelerate and decelerate quicker improving throttle response and car control. Precision CNC machined to remove excess weight without reducing strength.

• Only 17 grams per pair!
• Heat-treated alloy steel
• Uses metric 10x16mm bearings
• Fits SC10, SC10.2, RC10B4.1, RC10B4.2, RC10T4.1, RC10T4.2
• Can be installed on older B4 and GT with updated transmission housing/bearings

Lightweight 10mm Steel Ball Diff Outdrives
$45 set

Same outdrive as above with 3/8 inch (0.375) ID bearing for B4 and GT transmissions
$45 set

Lightweight Idler Gear Shaft

Super light hollow aluminum idler gear shaft. Precision machined to remove excess weight without reducing strength.

• Only 0.2 grams!
• 75% weight reduction
• Heat-treated 7075-T651 aluminum
• Precision ground 3/16 inch outside diameter
• Replaces stock steel idler gear shaft
• Fits B2, B4, T2, T4, SC10, SC10B, etc..

Lightweight Idler Gear Shaft
$8 each

Lightweight Milled Motor Plate

Super light milled aluminum motor plate. Precision machined on both sides to remove excess weight without reducing strength. Area under motor is milled on opposite side to increase heat transfer from motor. Extra deep grooves increase surface area for better cooling and is much lighter than the milled factory team plate.

• Only 13 grams!
• 35% weight reduction
• Anodized aluminum finish (black or blue)
• Replaces stock motor plate
• Fits B2, B4, T2, T4, SC10 , SC10B, etc..

Lightweight Milled Motor Plate
$20 each -Out of Stock, shipping TBD

©2025 Lunar RC